2 Black Desk Grommet, Plastic Wire Organizers, Computer Cable Hole Cover Plug Cap Insert(5 Pack)

these fit very nicely and help to hide some of the cable mess i have for my computer.

Worked great. Used one these to modify the center console organizer in a tahoe so that a box of tissues could be placed under the organizer and the tissues be dispensed through one of these.

What can I say. It is what it is and does what it does. Great price!

...and theyre doing an excellent job. Theres nothing I would change. Would buy again.

Other reviewers evidently got something different than I did today (12/13/21). After reading the reviews, I waited to receive my order before drilling into my project. I had already used my 2-inch hole saw on a scrap of plywood to test it. When my order came today, it slid in with only a VERY little gap around the edge. Not overly snug, but certainly nothing that needs shimming. It will turn easily within the hole, but not jiggle around loosely from side to side. In other words, exactly the amount needed. Im using it inside a workshop wall cabinet so that a cord to my power tools battery chargers on that shelf can go through from the wall receptical.

Installation without any problem. Cut the hole to 2 and it just pops right in!

good value

As described. Reasonable build quality. Put a couple wraps of electrical, masking, etc tape around the outside of the sleeve for a tight friction fit in your bored hole. Doesnt look like cheap plastic junk, but it is plastic.

I purchased the 2 grommet pack, and after drilling the recommended 2 holes in my desk, the grommets fit extremely tight. I would recommend a 1-15/16 or even a 1-7/8 hole for a snug fit. The grommets are mostly worthless for my cause now, I bought them to help your cables in a smooth manner, and now I have cheap grommets that do not stay flush as they should. Had the seller mentioned a smaller hole was required, I would be much happier with my purchase.

I put these in a desk to help with cable management. I didnt use them for the top of the desk; instead I put them in the side because thats what worked best for my setup. The 2 hole is a little large for the side of the desk and the grommet wouldnt stay put when I put it into the hole. That was easily fixed by some black duct tape wrapped around the outside of the grommet to make it a bit thicker. It makes the plethora of cables look slightly less messy.