2-in-One Drip Irrigation Tubing Hole Punch Fitting Insertion Tools Drip Tube Hole Punch for Easier 1/4 Inch Fitting & Emitter Insertion (Pro Punch Tool Sets)

Last year I used a hand drill with 3/16 drill bit to drill holes in 1/2 hose to connect to 1/4 hose. I thought a punch hole tool was useless. I was wrong. With these two tools, the time to set up an irrigation system is much faster than before. The punch tool always does the job with one punch. It never fails. The other tool for insertion is a little difficult to use. It takes some time and strength to put1/4 hose into its groove. But I still use it as it is harder to use bare hand to do the same job.

Last year I used a hand drill with 3/16 drill bit to drill holes in 1/2 hose to connect to 1/4 hose. I thought a punch hole tool was useless. I was wrong. With these two tools, the time to set up an irrigation system is much faster than before. The punch tool always does the job with one punch. It never fails. The other tool for insertion is a little difficult to use. It takes some time and strength to put1/4 hose into its groove. But I still use it as it is harder to use bare hand to do the same job.

Don’t wast your money. The punch did not work AT ALL. The other piece, used to install drippers, worked well for about 10 drippers, then deformed. It is also useless now.

The punch works as advertised on 1/2 tubing. The insertion tool only works on straight barbed plugs and cant be used for anything else such as a barbed tee. I wish there were a recess for any of the possible 1/4 fittings. No matter, with severe wrist problems, I had to figure out a way to connect 1/4 tubing onto any connector. Tubing is stiff, so the trick is heat just the very end of the tubing with a hairdryer on hot for just a few seconds and it slips right on. If you heat more than 1/4 at the end tubing it will buckle and permanently deform. Wetting the barbed connector lubes the process too.

Works great

The clamping punch works well on .700 or 1/2 inch tubing but foes not cut through 1/4 inch. The hand held cutting is deformed and cuts 90 to 95 percent leaving a chad holding the cutout. UPdate the clamping punch will not punch the oval .700 tubing

Tried to make a hole in the pipe with the plier looking device,,,would not make the hole. I bought a different device from home depot and it worked perfectly.

We used this on a nationally know name brand drip line. I am fairly young and healthy and this took A LOT of force to punch through the line. My father who is a life long farmer could not get it to punch through. He said I should throw away this piece of crap.

Didnt fit any pipe I have regardless of the adapter used. Went in the trash the same day I received it.

Clamping punch is really slick. Has a removable insert to accommodate variable distribution hose diameters. Has compartment in handle for small connectors. Push punch works well. Has cut out in handle for pushing drip hose and fitting into distribution hose.