2 Set Replacement Roller Brushes Compatible for iRobot Roomba E & I & J Series, i7 i7+ i3 i3+ i6+ i8+ j7 j7Plus E5 E6 E7, Vacuum Cleaner Accessories, Multi-Surface Rubber Brush

Like all 3rd party brands, the Roomba often throws an error saying the new rollers need cleaned. These must create some resistance like that of a hair ball. You take them out, put them back in, it cleans for 15 minutes more, then it does it again. Last time it took three times before it was content and finished the job. After that, no worries. However, for the price, its still a great deal.

1 hair, 1 week & roller is cut in half & ruined. Not the same materials as original iRobot rollers, thin & weak. I had never seen a complete collapse in the middle of the roller within 1 week. Quality is not this product ! Buyer Beware - no value here !

Te price is good and it fit my IRobot perfectly

If I could give this 0 stars, I would. these brushes nearly broke my Roomba. The quality is Awful. The brushes melted into the plastic of my Roomba. I had to use a hair dryer To melt it again and pop it out, otherwise the brush would have stuck to my Roomba. I didnt want to spend full price on Roomba parts but these poor quality parts almost cost me my vacuum. DO NOT BUY!!!

The plastic/rubber on these is a bit soft and chews up easily causing rough edges which then trap rug fringes and cause premature destruction of the roller ( like in two days). I wouldnt buy these again.

Wasn’t sure if these would work on the rumba I bought at Costco like 5 years ago (I believe it’s a variation of an 8). They worked great. Just know that you will need to remove the plastic clips located on the ends of the old rollers in order for these to work. So, don’t throw out the old rollers until you’ve got the new ones installed.

I love places that sell the rollers just on their own because I somehow go through them much faster than the brushes and filters. Probably because there’s lots of hair in our house of women and they break up the rollers and cut them lol. These are a great replacement and work well, and are much more affordable.

Noises from new rollers

So, these seem to be direct replacements for the factory Roomba rollers. They appear to fit my E5 normally. I say “seem” and “appear” because my roomba is a lot louder than it used to be, lots of random noises, grinding, etc. If this was only roller friction on the floor I’d expect it to be more consistent. The noise is a bit hard to hear on the video (the rollers are clear of debris, nothing stuck, removed and reinstalled to be sure). The OEM roomba rollers didn’t make this noise that I recall or I’d have thought it was defective. I’ll give it a week if use to see if the rollers are simply rubbing on the floor a bit more than OEM and update as needed. Update: these rollers are getting more quiet after running for a few days, as I thought might be the case. I suspect the raised ribs on the rollers were just a smidge longer then OEM. A bit of wear and they’re good to go.

These rollers are a perfect fit for an I7 Roomba. Installation was straightforward. Just release the original rollers (look for the green pin), take out the old, and replace them with the new parts. It took me all of 30 seconds. Incidentally, I ordered these rollers thinking that it was just about time to replace a few worn parts. Come to find out the original rollers were severely cracked. Heres my takeaway: examine your rollers from time to time, they do wear out. luckily these are an ideal replacement.