













3D Printer Glass Bed Clips Clamps Adjustable Fixed Clips Compatible with Ender 3/3 Pro/V2, Ender 5/CR-10, CR-20 Pro, CR-10S, Aluminum Alloy 3D Printer Accessories 3D Printer Heat Bed Clips (8)
-
Andrew Peterson
> 24 hourIf you thing these are what you need. This brand is good
-
Happy Camper
> 24 hourIve tried a couple other variations of these and this is the best style for a 3d printer glass bed that Ive found. They are a bit deeper than the stock metal swivel clamps that came on my ender 3 max but they hold the bed much more flat and securely. You lose a few mm of bed size but imo, its well worth it.
-
Jordan
> 24 hourI just attached one to each corner of my 3d print bed and I have no issues with my print surface shifting. I was using paper clips before and I much prefer these.
-
Grumpy Giant
> 24 hourI replaced the old binder clips on my Ender 5 Plus with these aluminum units. I like the strong mechanical hold these provide though I dont think I would call it necessary, and I feel a caution/warning should be made: It might be possible to damage an aluminum carriage if you tighten these clamps down hard enough. If you like overkill or you want a strong mechanical hold on your glass bed, these are the clamps for you.
-
Alex Wolfe
> 24 hourI bought these bed clips thinking they had rubber padding on the insides. I am planning on using bed clips with a glass / borosilicate plate and don’t want to damage it by tightening down metal clips on it. I think I will return these for ones with padding on the inside.
-
Mack Kidd
> 24 hourThese clamps are easy to install and hold very secure. Much better than the clips that come with most build plates. Care should be taken if used with an auto bed leveling device to ensure the nozzle doesnt hit the clamp during probes
-
Electronics Engineer
> 24 hourI used binder clips for a long time my Maker Gear M2- they work but can get in the way and have a tendency to jump off at the worst times. These are simple, low profile and work well. Keep the knurled knob on the bottom side and there is a tiny footprint on the top build plate. Really nice solution especially for the very reasonable price. I couldnt make these in my shop any cheaper or better and they wouldnt have the nice black anodized finish. Good stuff.
-
Jaquars
> 24 hourTo small
-
ADM Rc builds and reviews
> 24 hourWorking as described
-
R. Jackson
> 24 hourI have a number of 3D printers. Some have glass beds held in place with paper clips. This is sub-optimal since the clips keep getting knocked off when printing close to the edges of the build plate. These clips solved the problem. They are very low profile and small enough that I have unrestricted printing. I wish I had found these years ago!