3D Printer Heatsink Kit + Thermal Conductive Adhesive Tape, Cooler Heat Sink Cooling TMC2130 TMC2100 A4988 DRV8825 TMC2208 Stepper Motor Driver Module (22pcs)

Did there job. Let me make my Ender 5 Plus a true dual Z-Axis printer.

They work nicelly. I only used them for a small project of mine (custom made video capture card) and, coupled with two 25mm fans, it barelly heats up anymore.

This set of heat sinks comes in a plastic case. They each have a double-sided sticky pad and are very easy to install. They do a decent job of conducting heat away from critical components.

Using it for mosfets, rpi3, 3d printer stepper drivers. Got non issues so far.

Sticks well. Designed and built well. Would by again for smaller applications.

I have no idea how well the adhesive transfers heat, but nothing has burnt up. They stayed stuck.

Fantastic heatsinks! Only thing is dont forget to peel off the blue protective plastic coveting tape on the bottom, its a thin of plastic layer to protect the actual white thermal adhesive tape under it. After removing the blue tape, the adhesive on the actual heatsink is very sticky and seems to be pretty high quality. Just dont forget to use 91 percent isopropyl alcohol and a q tip to thoroughly clean the top of the chip youre trying to place it on to allow the best mating surface for the thermal adhesive to bond to. Try to get the position perfect the first time onto the chip or ic, otherwise it will reduce the effectiveness of the thermal glues thermal conductivity and adhesive properties if you have to reposition or remove the heatsink after it being placed onto the chip, after placing on top of your chip, apply direct downward medium force pressure on top of heatsink with your thumb, being careful to not shift or move the heatsinks position on the chip, apply this pressure for for 15 to 30 seconds to allow for a strong thermal and adhesive bond with the chip and you will be happy. Seen people complain about these heatsinks that they dont work, that they dont stick well, they most certainly do, it is just that those people probably are not installing them correctly, just figured I say something. Follow my directions and you will be happy!

Used these to hopefully help my Roku Streaming Stick run cooler. I tried to use a little HDMI extension cable, but that didn’t work. So I cut a small rectangular hole in the case and stuck three of these to one of the big metal bits inside. Should help everything run a little cooler. Adhesion seems acceptable. UPDATE: seven months later, I haven’t gotten the overheating message once and the heat sinks have stayed in place! Cheap fix for a really annoying problem!

Good ahesion, easy to install.

I purchased these little heat sinks for the vrms on my mobo as it was not equipped. When I saw they were available in blue I snapped them up because most on my case accented were blue too. They work very well according to temperature sensors display. Nothing worse than having a burnt out vrm and choke to ruin a good motherboard.