3D Printer Resin Filter Disposable – with Cone Silicone Resin Funnel(Large), Paint Strainer or Resin Strainer kit for uncured Resin Recycling (101)

The mesh is slightly too small for this purpose. It tends to get clogged but theres enough to switch them out as needed. Would still recommend!

I don’t use the funnel honestly because I need a wider mouth on it. But the paper filters work well for my 3d printer when filtering resin.

The paper filters almost seem a bit too large for the funnel, but it works.

A must have for resin printing

It’s a rather small funnel that will stay in place thanks to its design. Maybe it’s me but it creates an airlock, meaning you have to lift it to get the resin to empty through the filter back into the bottle as it seals at the opening. Not what I want to juggle when trying to empty the vat. I’ll give it a 3 because it does funnel and doesn’t make that much of a mess. YMMV.

Flimsy paper filters, tiny little funnel. Hard pass.

Fits perfect in top of resin bottle. Easy to clean. Filters are the best. Thumbs up

The funnel is silicone and easily cleaned with ipa or left in the sun to harden the resin which then simply falls off if you bend the funnel. The filters work fine for resin. The filters dont fit the funnel, which makes them less than perfect.

The included paper filters are torn. The silicone filter also has a slice in it from the factory.

My issue with these filters is the funnel tha comes with it doesn’t fit the filters so it sometimes wants to fall over.