5 Inch 8 Hole Hook and Loop Sander Pad For DeWalt , Makita , Porter Cable Orbital Sander - Fits DW421/K, DW423/K & BO5010, BO5030K, BO5031K, BO5041K & 390K 382 343 Replacement Sander Pad

Works great on a makita orbital sander.

I was hopeful after reading the other positive reviews but these are cheap knock offs that warp when installed. Instead of having a flat sanding surface, it is wavy. I believe it is due to a combination of the installation screw holes not being bored out and the backing plate being too thin and cheap a material for this purpose. As the pad returns to flat when removed, I tried loosening the screws, but no luck.

If I could give it no stars I would! broke within 2 minutes of use. My brother and I have over 50 years woodworking experience between us. WE know how to use our equipment properly so it was not from misuse that this pad broke. I put it on and as soon as I touched it to wood it busted through the plastic on the back and flew off the holes that screw to the sander widened (plastic chewed up). I thought it was maybe just a fluke so I put the second one on and it did the same thing. I have a dewalt sander and always buy the dewalt replacement pad but tried to save money and wasted it instead!

Made my Dewalt 421 like new again.

Screws burned through the holes and pads flew off within 15 minutes of use. Super cheap material

Holes did not line up on Craftsman sander, had to drill new holes in pad for it to fit.

Needed a new pad for my orbital sander. I left mine in a hot attic and it deteriorated. This was the exact replacement and is working for me. I am able to sand again.

Me ha gustado bastante, esta de acuerdo con la descripción

Used to have to replace these pads every couple of months when my cabinet shop was busy. Now that Im retired, my hobby work is a lot less demanding. These fit perfectly on both my DeWalt and Porter-Cable sanders. The hooks grab the sandpaper firmly and therefore fulfill their sole purpose just fine. Will buy again if I have to. Price for two is less than price for one DeWalt branded replacement.

I know, I know it says it will fit a Makita B05010. Not so. Oh, its close. So close that you might be tempted to try to make it fit. The first screw - fine. The second is where you get that feeling, but with a little persuasion you can get it to go. The third and last screw........ well go ahead and try. It will go in..... on the diagonal. Unless you enjoy cross threading and damaging your sander, I would just buy something else. I ended up very carefully re-drilling the hole and got it to work just because it was easier than the return hassle. I figured if I ruined it, Id be done with it. These pads seem to work fine, Just not on a Makita B05010.