5PCS A4 FEP Film for Elegoo Saturn 2, Saturn S, Saturn 8K, Anycubic M3 Premium, Mono X 6K, Photon M3, M3 Plus, Phrozen Sonic Mighty 4K LCD 3D Printers, 210x300x0.15mm Resin Vat FEP Film Replacement

Was very happy with this film. Did the job great, held good and was satisfied with it. Price was pretty reasonable, better than most. Shipping could have been a little better, but luckily it wasnt damaged. Very satisfied with it.

This is some good clear FEP film. It fits my Elegoo Saturn 2 8k with lots of FEP to spare. Its so big you almost feel like you are wasting some on the Saturn 2 8K, even if it is only about 1 inch of FEP film on one long and one short edge. Im amble to produce good prints using it. Just follow the instructions for your printer and youll be fine.

I purchased another brand of these a few months back here on amazon that also shipped via prime and the packaging left a lot to be desired. I had planned to use one of the fep sheets as a screen protector but the crease was so bad it didnt wanna lay flat even when I tried taping it down tight. The creases arent as much of an issue for use as a normal FEP sheet since the mounting and tensioning process pulls all but the worst creases out so you could say the product worked as advertised. This time when I ordered I hoped things had changed in packaging department but again it was folded in half and shoved into my mailbox. I dont blame amazon for this since the packaging itself can be creased on corners quite easily just by handling it. That said, these work fine for use as a FEP but Im knocking a star off for those of us who want to use them as a screen protector under the FEP as well.

5 FEP sheets for this price is a no brainer. I cannot say they work perfect but once you learn to tension properly then calibrate lift speeds properly you will have no issues with most FEP sheets so save some money by learning how to tension/calibrate rather than having to be stuck with expensive FEPs.

more flexible and more clear than original manufacturers, also half the price.. printing down to 8k

Sized just fine for my Saturn 2 and you can always cut it down to fit smaller resin printers. Since FEP film is a consumable its always good to have extra sheets handy.

I got this FEP and recently installed it in one of my resin printers. Installation was pretty straightforward with no issues from the FEP. The size of it is big enough to fit any of my printers that i have and they are all different brands. If you dont know you will learn but resin printing is faster than your traditional FDM printing and the part that wears out most is the FEP. That means having a good product on hand to do replacements is key and this product fits the bill perfectly in every regard.

At 210 x 300 mm, these FEP sheets are way too large for my little resin printer, but theyre easy to cut in half with sharp scissors or a knife, so I end up getting 10 sheets for a pretty reasonable price. They are exceptionally clear - great for just about any resin printer. Installation is easy - just follow the instructions for your printer and be careful to get the film nice and tight. Also, make sure you remove the protective film from both sides. Thats actually the toughest part of installation for me!

I used these on my creality halot pro and they worked great. I installed the film and then trimmed to fit. I had a successful print the very first time. I will continue to buy this film for my replacements.

My colder environment leads to prints that stick hard and FEP damage at an accelerated rate. I change FEPs a lot more frequently than most. The nice thing about these larger FEP films is if you run multiple printers theyll work for a larger Saturn and its exactly double the size of my Mars 2 so I can cut a sheet in half and get two FEPs for my smaller printer as well.