5PCS FEP Film 200x140x0.15mm for ANYCUBIC Photon, Photon S, ELEGOO Mars 2 Pro, Mars 3, Mars 3 Pro, Phrozen Sonic Mini 4K, Creality Halot-one, LD-002H LCD 3D Printer

I have 3 elegoo mars pro 2 and havent had a issue sense

Product came in large sheets. 5 pieces. Large enough that I can make 10 FEPs for my photon zero. They release great and print reliably.

Multiple sheets come a little bigger than the bat itself leaving plenty of room to adjust and get the proper fit.

Cheap, easy to install, multiple sheets, it works

This would not work with my Anycubic Mono that was purchased in 1/22. It has a FEP quick replacement vat and you cant replace just the FEP...the frame isnt removable. Product not eligible for return either. Bummer

There is a short video on how to replace these for my printer (AnyCubic Photon). A lot of screws but in the end it was very simple and took no more than 5 minutes. Clean everything off first and make sure you have a bottle cap from a soda or water, place it under the film as youre replacing it to create the tension on the first set of screws. Remove it when re-attaching to the VAT and it goes on nice and tight. Use a razor or x-acto knife around the inside edge to easily remove the excess and youre good to go. I tested a print almost immediately after that was an issue, I just re-zeroed the printer since it was slightly off and voila, back to perfect prints!

Installed on both vats of my Photon printers, works fine, no problems

Worked great. Quick shipping

Bought this as my first FEP replacement to my Anycubic Photon 4k. Prints started consistently failing so I figured it was time to change it. Now my prints are coming out perfect. And I totally didnt forget to take off the protective film of the FEP before installing it. So dont do that thing I didnt do...

Used it for my AnyCubic zero. Did the trick. Had to watch a youtube video in french to figure it out, but it worked once I did.