6 Foot - Balanced Microphone Cable CUSTOM MADE By WORLDS BEST CABLES - using Mogami 2549 (Black) wire and Neutrik NC3MXX-B & NC3FXX-B Gold XLR Plugs

Device: RME ADI-2 DAC FS & THX 789 AMP.

The 2549 Mogami is a very good XLR cable to use between Dac and Amplifier. May be use 2534 Mogami if interference is an issue.

great cable, highly recomend seller and product

Best product I found for this price!

A very durable and steady cable to use. After using for a few months, theres no issue and its a really good length for me. Very nice product.

Excellent quality, dead quiet at a small fraction of the cost of the $ brands. Same Mogami wire you’d pay $70 for.

Very good sound for a very reasonable price. Quality is top notch.

Quicker than ProAudioLA, and cheaper than Guitar Center! A+++

Replaced my Amazon XLR cables when I was noticing distortion emitting from my front main speaker. I switched cables around and the noise disappeared. I decided to investigate and looking for better cables that not only had better end connectors but eliminated outside noise interferences and led me to these XLR cables. Once I plugged them in, I immediately noticed the humming from the Parasound amp disappeared and the music was much more defined and more focused at all frequencies. I wish I would have found these cables sooner. These XLR cables are a bargain at this price. Dont hesitate to buy them. You will be wasting your money on more high end cables.

I had to replace my original poured because I was still getting interference from a monitor that sits very close to it. After I was able to identify the source, even turning out the monitor did not solve the problem as it was still plugged in. Replacing the cord I found it to be a very pliable solid cord, and the end clip snap in nicely in both the microphone and the mixer. If I ever need another one I definitely will purchase this.