









6 inch with 48 Holes Hook and Loop Backing Pad for Air Sander Polisher, 5/16-24 Thread Max 13000RPM, Pack of 1
-
Lady Slay 76
> 24 hourThese work great! You just slap them on the polisher and go! Easy install and great adhesion. Must have with this polisher.
-
michael
> 24 hourI bought this for buffing my boat and cars. Said it was hook and loop but was not. I still use them for polishing pads with the drawstrings.
-
Mel K
> 24 hourMy old wore out da needed a new backing and this worked perfectly. Went on the same way the other came off for an easy install. lined up properly and seems to be holding up well and i have been sanding a good bit this past week on casing walls and ceilings so i have put it to the test!! Nothing bad to say about the will buy again when mine wear out and paper wont stay on anymore
-
William G.
> 24 hourThese hook & loop backing pads have been holding up extremely well,especialy considering that these cost pennys on the dollar,when compared to the big USA made name brands.
-
TOYnn
> 24 hourLooks to be very well made and should work for the right air sander. Unfortunately for me it doesnt fit mine - my mistake as I wasnt aware of differences.
-
TVM
> 24 hourThis sanding paper is great and fits my sander perfectly.
-
Mark A. Jones
> 24 hourJust what my old sander needed
-
avihay ismann
> 24 hour.!..excellentnt. work very good
-
Thisguy
> 24 hourThis a great replacement if you need a new backing pad. It’s a good value for a two pack. I have a Porter Cable orbital polisher and it fits and threads perfectly. It’s adheres to the foam pad pretty well. I have had other pads that adhered more, but this does a good job of holding the foam pads and will get the job done.
-
Josh Wilson
> 24 hourWarped in 2 seconds