8mm OD 20mm Long Light Load Compression Mould Die Spring Yellow Compression Mould Die Spring for The Ender 3s Bed 20pcs

I bought these for installation on an Ender 3 print bed, replacing the OEM spring set. These were noticeably stiffer than OEM, meaning the bed is being held more firmly. A tip for Ender 3 users is to trim a turn or so from the spring to be used on the corner with the bed heater feed line. There is a plastic support there that takes up a bit of space. If you use an unaltered sprint, that corners adjustment will max out before the other 3.

Used on my Ender 3 pros print bend. Stronger and steadier than the stock ones. Highly recommend the upgrade.

I installed these in my Ender 3 Pro bed; they work nicely in place of the stock springs, which were somewhat weaker. The firm springs keep the bed more stable. Nice fit and finish. Recommend.

Perfect fitment and stability for Ender 3 V2. Must have upgrade.

Bought these to replace the stock springs on my Ender 3 v2. Theyre much stiffer than the original springs, and make bed-leveling easier and much less frequent.

I am confused by all the other reviews stating these worked well with their ender 3 v2 printer. I was excited to install these, but even at full compression they are simply too long, and the bed is not able to go low enough without contacting the nozzle at the home position. I tightened down the leveling knobs all the way to where the coils of the springs were completely touching and could not go any more. I still needed the bed to go about 1-2 mm lower. I still plan to use these and just cut off one or two coils. They are much stronger, and seem like they would work well, just frustrated they advertise they fit the Ender 3 V2 when they didn’t fit my stock setup. It may have to do with the bed surface thickness you are using. I am using the textured glass bed that comes with the printer. If you have a thinner bed surface these may work fine.

These works well on ender 3v2. It definitely made a difference in how long my bed stays level.

The springs that come with the popular 3D printers are crap. They cant hold position for an entire four hour print. Get these. I used the stock knobs as I did not want the extra wide knobs that are available to get in the way of my Y axis or display. After installing these and doing four corners and the center until all of them had the same drag on the paper I did a thirty hour print. Turned out very nice. I let the bed cool down overnight and checked the corners again and they had not moved. Same drag on the paper. So I got twenty of the springs on this order. I installed four and have four as spares. That leaves me a dozen to use to upgrade three printers at my local High School so they can print hassle free!

Received 7 springs instead of 20.

Put these in a Creality ender v2. Once the bed is leveled it seldom needs a touch up, only when I remove the glass bed for a scrub down. You cannot go wrong here.