AFA Tooling Long Reach Extendable Neck Deburring Tool with 4 High-Speed Steel Rotary Burr Removal Blades | Works on Copper Pipes, Metal, Resin, PVC, and 3D Printed Plastic Edges

This is a must have if you find your self drilling holes into things alll the time. You can use this to clean up the edges and give it a nice finish. Comes with an extendable tip which is neat and also comes with two different size tips. I really wish it handle was hollow and had space for the other tip so o could store it inside of it. I will likely lose the smaller one that I won’t use often but not need. Knocking a star cause I had an older one that did have storage in the handle and I miss it. This one trades the extension for the storage so I see the compromise. Overall nice quality sharp tool should last me lifetime if I treat it right

I usually do good then bad. Im going to reverse this. BAD: I read another review that said the storage space inside the handle was too small to hold the blades. That is NOT true. That user just didnt know what they were doing. In the end cap that is removed to access the storage there are slots, about 10 of them, to hold blades. If blades are seated in those slots the storage area holds them just fine. If instead the user just tries dumping them into the storage area, they ARE too long. Dont do dumb & itll hold the blades just fine. There is an issue, though, with the storage. The release buttons are positioned so that it is nearly impossible to remove the end cap. You have to push both buttons & then pry the end cap off. If youre fingers were the size of chopsticks, yet you had the strength of a grown man, itd be fine, but even tiny fingers are far too large to push the buttons. The surrounding plastic prohibits it. I got around this by pushing on each button alternately with a tiny screwdriver, forcing it incrementally one side, then the next, then back again, until I got it out. So that I dont have to repeat this ridiculousness I put the cap back in without allowing the buttons to protrude in their designated slot. Now I just have to pull the cap off to access the storage area. The blades arent labeled, nor is there a spot to hold one set of them, making the whole blade storage pack seem lack an afterthought from a hung-over designer whos head hurts too much to do anything useful. The system that allows you to extend the blade also allows you to retract it so far you cant change the blade. Its easily remedied, but is still a dumb design flaw. The mechanism for extending the blade is very stiff & hard to activate. GOOD: Ergonomic. Feels pretty good in my hand. Extended reach feature is snazzy, locking in place at set intervals, and extends quite far. It seems like a decent value, but longevity of the blades is yet unknown.

Feels solid and comes with plenty of replacement blades.

Very versatile and great economically with the extra blades.

This is FAR better for deburring than trying to use a countersink drill bit. The 2-edge design cuts way better, especially by hand. I should have bought one of these 10 years ago. Gives that nice, zero-drama finish to any drilled hole. Comes with 2 diameters, so you can get into smaller/deeper spots with it. My only complaint is that it doesnt ratchet. Cant take a star off; it still works well, and its well worth the money.

The only downside is it doesnt seem to fit the inserts that my shop carries

I previously wrote a 1 star review because the item had not been delivered on time as promised. However, it did arrive, albeit, three days late. The product is as described and very nice.

Workes great

Exactly what I was looking for a good price

I work in a machine shop, this product is a decent value. I DEBURRED AN ENTIRE iron V10 engine block without issues on a single tool head. Did exactly what it was designed for. Are there better cuttinf bits out there? Probably.. but for the money. Zero complaints. Comfortable for my size hands too.