











amFilm Screen Protector Compatible with Nintendo Switch OLED model 2021, Tempered Glass, 3 Pack
-
zhujun cheng
> 3 daygood
-
E. N. M.
> 3 dayI’ve used this brand before and it’s been great.
-
E. Fisher
> 3 dayThis is a vine review meaning the product was provided to be reviewed. I ordered the screen protector for my daughters new Nintendo switch. Over the years I have installed many screen protectors on iPhones, iPads, Nintendos, and other devices and am quite familiar with the procedure. For this installation, I first cleaned the Nintendo glass with Windex and dried it thoroughly. Next I used the wet wipe included with the protector followed by the dry wipe that was also included. I tilted the glass and insured there was no dust or other particles. I carefully removed the plastic backing from the adhesion side of the screen protector and aligned it in place, and used a finger down the center of the protector to remove air, per the instructions. I was surprised to see a particle under the protector because I had been very careful to thoroughly clean the Nintendo‘s glass. I removed the protector and got a new protector from the box because three are included. I then cleaned the Nintendo glass with a new wet wipe and a new dry wipe from the package. Following the instructions I installed the protector. I was again surprised to see a single particle in a different place under the protector. Both this particle and the previous particle were larger than dust, about the size of a grain of sand and appeared to be squarish and not round. I have never had this happen when installing a screen protector in the past. It is perhaps possible that I am at fault but it is also possible that the particles were already on the protector before I installed it. Because this happened twice, I do not think I am at fault and I am reluctant to recommend this product.
-
TBK.
Greater than one weekHaven’t had a crack yet so I can’t review on how well it protects the screen but it was super easy to install and you can’t even tell that it has a protector on it
-
Old Ben Kenobi
> 3 dayIt had tabs to hold to make the installation easier. Just peel one film back and while holding the tabs lower the glass onto the surface. Take your finger and run it vertically down the screen. If any bubbles remain towards the edges you can lift that side slightly and reapply.
-
Susana
> 3 dayExcelente
-
Bethany B.
> 3 dayThese are great, I accidentally removed the tabs you are meant to lower it into the device with, but it still went on perfectly centered and one finger swipe is enough to get it fully adhered with no bubbles left behind. Ive used tempered glass screen protectors on all my phones, tablets, and handheld gaming systems for years now and these have been the best so far!
-
Damien M.
> 3 dayGood