anidees Aluminum Heat Sinks Extra High Pi Case with Silicone Thermal Pad for Raspberry Pi 4 Model B Black (AI-PI4-BB-PRO-H)

Overall good quality, but one of the top holes wasnt properly threaded to the end so I had to back off the other 3 as well. Was expecting better quality control at this price point. But other than that pretty good

The black coating isnt evenly applied. There seems to be a corner that didnt get the coating properly applied and I guess someone used a black marker or something to cover it up.

This is a great case. Very stylish looking with the acrylic top it offers excellent cooling and can be enhanced with a fan . Work great with the raspberry pi 4 8gb board.

Dieses Gehäuse lässt den Pi nicht schwitzen, er läuft auf ca. 30c im pihole Modus dahin. Ich will es nicht mehr missen

Fast shipping, sleek design, easy assembly. Looks great, I would buy it again; definitely!

With the cheap heat sinks and under normal CPU load the PI4 was doing about 53 degC and under a moderate load it was getting up to 70 degC. After the case was installed the temperature under moderate load was between 40-45 degC and normal load was about 35 degC. This was all without a fan and with a HAT on top. It was a little tricky getting the HAT installed, the same screw tap that holds the PI4 on the bottom of the case also holds the standoff for the HAT on the other side. I used a plastic standoff with a short screw thread sticking out. The only real downside is the cost. The case is well made and they give you an allen wrench and the silicon pads to transfer the heat to the heat sink. They also include an extra screw of each type and an extra rubber foot pad.

No dislikes whatsoever. Well made and just what I needed to accommodate my lightening detector for my weather station. This is my second case from them.

Probably, this is the best case I had ever seen and use. Height is enough to put inside original Raspberry Pi PoE HAT without a fan and fan HAT. Now I have nice looking cold and silent computer.

I ordered this case to house a Raspberry Pi 4 with a 4 relay hat, so needed the extra height. This case is beautifully made and of high quality, it fits the Pi with hat very well; there are small risers that fit between the plexiglass lid and the aluminium body that gives sufficient clearance between the top of the relays and the lid, and this also allows for heat dissipation. The black coating is even and well applied, the rounded corners very nice. Overall Im happy with this purchase, it does exactly what I wanted. So why 4* and not 5*? Minus half a * because its expensive, $50 is a lot for this. And minus another half * because the plexiglass cover had some manufacturing scuff marks on one side (basically scratches) near the screw holes - not bad enough to merit a return and replacement but still not ideal.

Fantastic case. Solid, professional and very well cooled. You cant beat Anidees cases.