ANYCUBIC Water Washable 3D Printer Resin, 405nm High Precision UV-Curing 3D Resin, Low Shrinkage Standard Photopolymer Resin for 8K Capable LCD DLP Resin 3D Printer Printing (Grey, 500g)

Works great with my Anycubic 4k printer.

This is some of the best clear resins I have used. A lot of what Ive used was still tacky and a bit soft after. But this one isnt. I had three pieces but the larger one is a bit brittle, not sure why. Something seemed off so I touched it and it cracked and shattered like glass. Its the only piece that did it. Thats the only real complaint that I have. I was also in a pinch and needed pouring resin. This works great if you have the right light.

Works as it should

My UV lamp sets the resin, but letting my prints sit in the Arizona sun for a few hours is the best.

Did a pretty good job. Do not pay for than $30. Sometimes leave white areas, I think Im not mixing it well enough. I think also the liquid is more thicker.

Made a mistake with an order and thought I was just out of luck. Messaged Anycubic and was shocked that they were willing to correct my mistake with out question. I was a Eelgo resin user but made the switch to Anycubic now. Havent had a print failure, its water washable and works great in the Saturn 2.

awesome details, great product

So Ive used about 4 different resins. All anycubic since they are affordable. I have only had 1 failed print and that was user error. I am loving this. With the wash station it cleans real easy and I have gotten oretty decent prints. Is it the best? No but is it great for an entry level 3d resin user. 100%

Overall the resin works well for doing miniatures. Recently I tried something bigger and it did pretty good as well. The really large one, I ran out of the grey and used the clear washable to finish the print out. You do have to pay attention to the print specs, when I first started I had a few failed prints because I wasnt using the right exposure time and distance. After that was straight, the dragon head was my first print before the figures.

Cleans very well with just water, you may need a small brush to clean tight cavities it tends to pool and leave a film if not fully cleaned off. Rinse for at least 20min in curing stations and a few minutes under flowing water.