Aokin 16 Pcs Extruder Nozzles 3D Printer Brass Nozzles for E3D V5 V6 0.2mm 0.3mm 0.4mm 0.5mm 0.6mm 0.8mm 1.0mm for 1.75mm Filament 3D Printer

These have been the best nozzles I have found. All the other nozzles are either poor quality or overpriced. These are just right and print with amazing quality. 10 out of 5 stars

Worth the money

They work fine. No complaints

Having clogging issues with the 0.2mm, but thats just part of the 0.2mm experience and not necessarily an issue with this nozzle. Make sure you keep your temps high and your print speeds low. Produced some great quality prints with a little trial and error.

Received the product. Very quick shipping. Not fully tested, but thus far works OK.

muy bien embalado, buena calidad

I tried one of these on my Prussia MKS but did not get a smooth bead. Put the old nozzle back after cleaning with acetone and the extrusion was smooth. I don’t have the equipment to tell if the 4mm bore is smooth enough In this inexpensive nozzles but seems to work fine for others.

The best thing about them is that they are cheap! For a few paltry dollars, you can get get an entire set, nay, several sets, of nozzles for your E3D V6 compatible hotend. I have tried the 0.8mm nozzle thus far and it did require recallibration of my Prusa MK3S but turned out a decent print. I was curious as to how accurate the nozzle diameters were so I put them under a stereo microscope and took some pictures. I then used the 0.8mm nozzle diameter as reference to measure the rest of them. All were spot on except the 0.2mm one which varied in diameter between 0.16 and 0.20mm, but given that this is almost surely going to be unused by me, Im not sure I care. The insides dont have burrs but they are not super smooth either: you can see the grinding pattern in the attached picture. Worth a buy? Yes, especially given that a single 0.4mm E3D nozzle sells for $25 on this site (dont know why!).

I was skeptical, but I have to admit, these did give me a very nice result with the .2 nozzle. I dont think it will iron very well due to the tiny bottom surface, but with a small print nozzle I dont know that Id really even need it. Looking forward to trying the rest of them!

Nozzle snapped off in my heat block 5 minutes after I opened the package. Do not buy these!