Aokin 16 Pcs Extruder Nozzles 3D Printer Brass Nozzles for E3D V5 V6 0.2mm 0.3mm 0.4mm 0.5mm 0.6mm 0.8mm 1.0mm for 1.75mm Filament 3D Printer

Cannot tell any print quality difference between these and my genuine e3d.

I tried one of these on my Prussia MKS but did not get a smooth bead. Put the old nozzle back after cleaning with acetone and the extrusion was smooth. I don’t have the equipment to tell if the 4mm bore is smooth enough In this inexpensive nozzles but seems to work fine for others.

Works great. Have lots spare, and avoid the hassle of cleaning a blocked nozzle

If you want to dabble in nozzle size changes this is a great place to start! Fit multiple extruders and gives me a chance to use these nozzle types before buying an E3D upgraded nozzle in the future!

Having clogging issues with the 0.2mm, but thats just part of the 0.2mm experience and not necessarily an issue with this nozzle. Make sure you keep your temps high and your print speeds low. Produced some great quality prints with a little trial and error.

These have been the best nozzles I have found. All the other nozzles are either poor quality or overpriced. These are just right and print with amazing quality. 10 out of 5 stars

They fit my E3D V6 clone heat block. Packaging could definitely be better, i.e., packed separately by size. I grabbed a .6 when aiming for a .4 and it took a few mm of filament and confusion to realize that I had a mismatch. I have since repackaged in small bags that I had saved. But, they work and seem to work appropriately. A close examination revealed good clean orifices, edges, etc., and performance has met expectations.

I was skeptical, but I have to admit, these did give me a very nice result with the .2 nozzle. I dont think it will iron very well due to the tiny bottom surface, but with a small print nozzle I dont know that Id really even need it. Looking forward to trying the rest of them!

Quality product but the large flat on the 0.2mm nozzle makes it basically an iron and it is difficult to get the detail your probably going for on very small parts.

One of the nozzles in the pack was very clearly already used.