Argon Micro USB Cable Power Supply 5.25 Volts 3 Amps for Raspberry Pi 3 and Zero Boards | UL Listed | 3.3 Feet Long Cable with Micro USB Connector | Micro USB Cable and Wall Charger

Kept getting under volt messages. This fixed the issue even under heavy load. Much better than the OEM power brick.

Ahh!! finally. I tried a bunch of chargers, plugs, wires, and finally decided to try this. I use 2 SDRs on my Pi and noticed even with 5v 2.5A usb chargers I would get lightning bolts on boot or when im doing heavy tasks. with this I finally noticed when I boot I dont have any issues.

Very well made. Heavy cable made to last

Works well with pi 3B with official 7” touchscreen

Works perfectly

I tried several power adapters and got a lot of low voltage warnings. Granted, they were chargers and not proper power supplies. No low voltage warnings since using this. Seems to be well made and the price is good. This provides plenty of power to my Pi and fixed my problems!

The voltage and current are good and it works with the pi ok, but if you have any accessories or hats that are sensitive to power noise this supply is not quiet enough, too much ripple. A Matrix One Creator would not work properly with this supply powering a pi 3 but it worked fine with a lower current Canakit supply.

I used to have low voltage warnings and usb devices attached to my Pi wont function properly. My devices are running smoothly after replacing the power supply.

Bought it for a retropie setup so that I wouldnt see the dreaded lightning bolt anymore and it worked.

My old Pi power supply died. I found two additional ones with exact same specs which threw low power errors. Purchased the Argon and all is well with the Pi again. Great product and a fair price.