ASTP&FH 2-3/4 Hole Saw with Arbor Mandrel ,HSS Bi-Metal & Heavy Duty Steel Design, for Metal,Stainless Steel,Cornhole Boards,Drywall,Plastic,Brass,Aluminum,Iron and Wood（70 mm）

Precision, durable, efficient. Great tool.

Good product for the money. Needs holes on the bottom to easily remove stuck wood

drive bit broke on first use... event when using a replacement but the tiny screw that puts pressure to the drive but strips and continues to loosen...

Did what I wanted but struggled to cut threw a relatively thin piece of metal.

It feels and looks very sturdy and very professional I would say once I use it Im going to be very happy but I havent used it yet

This is the perfect tool for cutting holes for dog food bowls love it. Have you used it quite a bit? Thank you

My wife decided she wanted recessed lighting in the kitchen at our cottage. That involved cutting out the ceiling. I decided to try and make the job easier by looking for a hole saw to cut the holes. After searching a bit, I found this one by ASTP & FH. This hole saw did a decent job cutting out the 4-1/2” holes in the ceiling I needed to install my LED lights. The edges were a lot cleaner than I could have possibly done with my coping saw. And cutting them was fast….I had a perfect hole in all of 30 seconds. My only complaint about this hole saw is the fact there is a lot of play in the saw when it’s seated on the bit. It wobbles noticeably if it’s not pressed down on a board or, in my case, the ceiling. When pressure is applied to it, it’s fine though. The quality of the steel used in this saw is fair at best. And the shank could use a better fastener. But all in all, it worked, and my lights are up. This hole saw is great for an occasional job, but I don’t think it would hold up for repeated use.

I needed to install some speakers on our boat. This saw cut into the fiberglass pretty clean. I drilled a smaller pilot hole before using the hole saw. This will line the saw up exactly on your mark. I gave it 4/5 stars because I doubt it would hold up in metal, but for fiberglass and some woods, Im sure it will cut several holes.

Checked set screw before using was very tight,backed out very easily the first minute going through a 2” x 10” ridge plate was a bit unhappy.Stayed relatively sharp.

Awesome quality