Banjo LS100-80 Polypropylene Y Strainer, 80 Mesh, 1 NPT Female

Looks great! Solid quality

First off I’d like to say I had a good experience with the seller, the seller did everything well. As far as the product is concerned I would not recommend this filter. I bought this to use as a mesh filter for my power washer in my power washing business. The first filter was delivered quickly but had bad threads and had to be returned. The second filter was delivered even faster and looked to have good threads so I installed it for use. I used a high quality PTFE tape on both the inlet and outlet connections, one connection was brass the other was PVC and although I used the proper amount of sealant and the fittings were more than tight enough both connections developed very small leaks. Could the issue be the fault of a bad installation? Possibly but I’m confident that in the course of 31 years of experience and thousands of installs I’ve completed in those years that the fault lies somewhere in the filter construction.

Works great and easy to clean. I use it on my pasture spraying rig.

I used this to replace a higher priced filter that developed a leak. While it does not have as much filtration, it is working fine and was priced much lower.

I tried over and over and over (six times) in four days to seal the output side threads to hold water. Now I have nothing on that system. Im looking for a similar capacity strainer, and that is proving difficult. Im guessing that the advertized operating temperature range is causing the failure. After it was installed the third time and began to leak it was noted that the temp. rating on the strainer and the info on the computer dont match. We are operating at 120 degrees F.. I purchased (2) of these, and the other is on a closed loop with a maximum temp. of 90 degrees F. and it has held so far. But needless to say, I am keeping a close eye on that one.

I needed a 1 strainer for a liquid packaging project and this works great!

The unit is very large but that wasnt a problem in my application. One of the threaded female fittings seemed to be a bit misshapen and I was concerned that it would not mate properly to the male fitting of my system. But, with some force my plumber was able to make a good connection.

I plumbed the 1 model into my home water system to remove fine particles of shale that come up from our well. It works great and can easily be flushed out into a bucket. No filters to change.

Great product. Came much faster than stated too.

With a 1 male-male brass fitting, I was able to install this directly onto my water softerner (line into the house). No leak (with plumber tape) and no reduction in water pressure.