BSIDE EBTN LCD Voltage Detector, 3-Line Display Non-Contact AC Voltage Tester Pen, Adjustable Sensitivity, Dual Range 6V-1000V/90V-1000V Electricity Sensor Live Wire Checker with Flashlight

It works great for what it is.

Nice equipment for DIY

Every once in a while you find a tool that does everything the manufacturer promised and more. This is a prime example. Unfortunately, the power switch is a rubber thing that can be easily damaged. It becomes very difficult to operate. Other than that I would definitely say that this is a fantastic investment.

Its a great overall tool to have.... I wish it had a 110volt amp meter

Close to being right on voltage wise, reads a little high without a ground. Reads just a hair low with ground. Wish the labels in the circles would stay lit so you do not have to remember the order of E, N, and L.

The functions work as expected. Detection wise, theres a sentivity setting for NCV. The issue is the probe sensor/antenna is probably not at the sharp pointy end, and behaving more like it is inside the unit. It will work detecting voltage for sure in an electrical socket or wire, and sensitive enough to differentiate between 2 adjascent wires which is the live one. However, the dealbreaker for me is the probe color scheme. The main Amazon photo shows a monotone color scheme for the probe. That is - the red probe is entirely red. But what I received was like the last photo in Amazon which as stupid and dangerously confusing black-red-then-red at probe coloring. Whats worse is the cap follows the long handle. So when you take off the black cap, the end tip is red! It is so easy to confuse black vs red! Did the designers never use the tool? See photo.

Nice product

With adjustable sensitivity, you can switch between low sensitivity for more accurate reading or high sensitivity distinguish/Non-contact mode to detect live/neutral wire. The large LCD display make it easy to read the measurement, the flashlight is a plus when you use it in the dark especially in case of circuit problem, the hard case protects the tester wherever it is stored.

Works well, small enough to fit in my pocket when I spot check New Meter sets.

Used it for 3 or so months? Then all of a sudden it just wouldnt power on any more. Tried new batteries and nothing. Kind of a shame because I liked it when it was working, despite being rather bulky it was kinda nice to have a tick tester, volt meter, and continuity tester all in one. Didnt last long enough for me to buy again though. Note, even though the tick tester has a bunch of lights, it only has 3 actual levels for proximity - low, medium, high.