Creality 3D Printer X Y Z Axis Stepper Motor and Limited Switch Endstop Cable for Ender 3 Ender 3 Pro (Pack of 3)

Exactly what I expected...I received a set of X,Y,Z stepper cables and matching X,Y,Z limit switch cables, for a total of 6 cables.

I bought because I had a broken connector on my extruder. I plugged the new extruder cable in to my main board and stepper motor. Extruder now moves backwards. Instead of repinning putting a multimeter on the new cable I replaced the plastic on the old one with the new end. I only gave 2 stars because I didnt use any of the other cables but I can only assume they arent pinned right either.

This is actually all 4 cables that youd need (X, Y, Z, and E), but the X and E cables are paired together and so the same length. But for an Ender 3, you need a longer Extruder cable than you do X motor cable. So now I need to figure out if I can get an extension, or just return these?!?

My Ender 3 Pro has a two piece extruder cable. It does not include the second piece.

Was exactly what it says it is, worked perfectly

Connected to the z axis and the pins are backwards, and the z axis is way to short

I would normally say that you are better off buying a crimping tool kit here on Amazon and make tour own wires (still a good tool to have for the 3D printer tinker IMO). However, my kits 6 pin connectors were slightly different in spacing than what the Ender 3 Pro NEMA motors required. This pack was a zero stress solution that works well. Also like how they come with the axis lable collets as well.

10/10 recommend

The Z cable is far too short. I wound up using the Y axis cable as a result. Fortunately, I didnt need to replace my Y axis cable, otherwise Id be SOL. For that reason, Im taking off 2 stars since one of the cables is effectively useless.

Not even as long as factory wiring. You will have to buy wire jst wire extensions to use these.