Creality Ender Enclosure Fireproof and Dustproof for Ender 3V2/Ender 3V2 Neo/Ender 3 Pro/Ender 3/Ender 3 Neo for Anycubic Elegoo 3D Printer 18.89 * 23.62 * 28.34/480 * 600 * 720mm

Makes it hard to route the filament from the side. The box is just large enough for the 3D printer, but filament keeps getting stuck due to the sharp 90 degree turn into machine.

Easy installation. I just love it. Worth the money and also it’s cheaper then the other stores.

Just bought two days ago. Easy to assemble. Glass fiber is strong and lighter than metal. Like a small room for my printer. My office no longer have plastic smell. Noise cannot be eliminated but is reduced for sure.

My son just got the Creality Ender 3 V2 Neo. It fits and the filament has just enough room to also fit. It keeps his printer free from dust and cat hair and helps is stay extra warm if printing with ABS. Zippers are tad hard to zip up and in down in the front and it’s challenging to get them to go over the frame if you need to unzip the entire front though.

Definitely keeps the heat in, and the peace of mind that its fire proof makes a big deal to me. There are bigger cheaper ones on the market though. I paid for the logo.

This enclosure is huge. No real clear direction to assemble it but wasnt hard to figure out. I got it for a Endeds3v2 and only problem I see is if you use the stock spool holder on top of the printer it will be taller than the enclosure. So youll have to feed it from outside of the enclosure but there isnt an opening in the side of the enclosure to do so.

This is nice and easy to setup. However, I wish it was about 5 inches bigger on each of the sides. Not much room inside once you put your printer in it.

At fist I thought there wasnt going to be room for the spool of filament. I centered the spool holder, and crossed my fingers that the filament making a u-turn into the filament detector would work, and it does.

Seems to work as advertised. Be warned, the rods used are the type of fiberglass that has tiny splinters, so for the love of all that is holy, learn from my mistake, wear gloves. Other than that, it takes up a lot of space.

This is kind of a generic print hood that should fit the average printer. It does a really good job of minimizing fumes and adds peace of mind. I haven’t printed at high heat, but this clearly keeps temps even inside to prevent warping.