D&D PowerDrive ORB-H-1101 Cub Cadet MTD 754-0461 954-0461 Kevlar Replacement Belt, 1/2 x 78, 4LK Section, Rubber

Good value

Used on Cub Cadet Super Lt1554 to replace 754-0461. Belt fit was loose and not at all right. Tried to use a stiffer spring on the tensioner. With tensioner at max still slipped. Absolute garbage. I suspect its a little too long and that most left reviews too soon. I literally couldnt climb a hill. The job to put it on can be extremely difficult if your pulley is stuck etc. Trust me doing it twice is absolutely no fun. Dont buy this belt

I replaced my drive belt with this one on a 2005 Cub Cadet LT1050. The fit was perfect. Only problem I had was getting the PTO Clutch off. It had rusted solid. But after watching numerous videos on what to do in this situation, I soaked it for a good 2 days with WD-40 and after a couple hits with a hammer and crowbar, it was loose enough for me to wiggle and giggle it til it came off. Cleaned it up, pulled the old worn out belt that was ready to break, put the new one on, snapped it all back together and it’s working Great... I recommend it for anyone who has the patience and know how to go ahead and do this. It saved me some Big Bucks

Heavy duty belt

I have used the D&D power drive belts for a few years now on deck drive and wheel drive applications. With that being said, I have never had one of them fly apart. Installed properly the belt will last a long time. Installing the drive belt is suggested in the owners manual that you have a professional do the work, Im no professional! What you need to do is drop mower deck and remove. Raise front of tractor and use jack stands or similar for bracing. You will need a 1/2 breaker bar or impact and a 15 inch adjustable wrench to remove blade clutch off of crankshaft. Place wrench on double flats just above bolt head in shaft. Use breaker bar or impact to remove bolt and clutch assembly. You may need two sets of hands for this. Replace drive belt in same configuration it came off. There is a picture in manaual that should show routing of belt around idler pulleys in middle of frame. When placing clutch assembly on shaft it helps to feed belt on to pulley at same time. DO NOT re-tighten bolt with impact, use a torque wrench and torque bolt 36 to 50 foot pounds. I went down the middle on specification. Reinstall deck, done!

Fit as it should. So far so good. Time will tell

It fit

Seems like it’s made well.

I did not dislike this product I dislike the seller.

This kevlar belt is the best for the money. It fit my Cub Cadet and made it drive like new.