Heat resistant. I used it in my engine bay and it is holding up really nice.

I used this to fix my LED strip, which had lost its original stick. After pressing the material between my strip and my table, I found it easy-to-moderately easy to trim the excess material. This resulted in a nice flush finish. Here is a pic of me tearing it off after a couple of weeks installed. If you pull fast enough, the material will even retain its position on the strip.

I got this for my coat rack. I secure it to the wall using grips. One of my grips was starting to loosen from the wall and it would have been quite the undertaking to replace. Instead I got this!! Only reason I gave 4 stars on easy to use is due to when you are trying to add it to a place where you dont have one side to start on. Getting the red part off is a little hard when not already against a surface (but doable if you are determined). When you have a surface - it is VERY easy to use.

Not that good would not buy it again

Tape had good adhesion and couldn’t believe how easy it was to remove

It may be two side but it doesnt stick to nothing. I try it on my picture on the wall the fell down. I wont never buy this brand tape no more.

did not hold the product up for more than 2 min and was very difficult to use and install

Great stuff. Used for a few projects. Holds very well.

This stuff does the job. Excellent adhesion and holding up to an exterior project in sub-freezing temps.

I dont knownwhy these sellers cannot post pictures of actual product. Product came about 1/3 of thickness of what picture shows.....make sure you read discription.