EANOSIC Upcut Spiral Router Bits 1/4 inch Shank, 1/4 inch Cutting Diameter Solid Carbide with Nano Blue Coating CNC Router Bits End Mill for Wood Cut, Carving, Edge Trimming

Im using this in my router for plunge cuts and not a CNC, but this bit works great. Its sharp, and it gives me clean and consistent results thus far. I really like it. Its a good deal, too (at ~$17.00 USD).

Has its own little protective case it came in and appears well made and sharp. Havent used it just yet but expect it to work fine. If it doesnt I will come back and update review

This bit is especially good at plunge-cutting dadoes quickly and cleanly. Its an upcut bit, meaning that it pulls the chips OUT of the groove instead of pushing them down inside, where they can slow cutting action. Weve not used this bit on a router table so far, but similar upcut bits are especially useful on a table because they actually pull the work down slightly, and help keep the piece tight to the table. Cant comment on the longevity of the bit because we havent had it that long, but no reason to think it wont last for quite awhile before needing sharpening. Recommended.

Amazingly good product. Absolutely satisfied. Thanks!

Very sharp spiral bit! Ive wanted an up cut style one for my router for a while now and they definitely seem to cut cleaner than normal styles. I use this with my hand router mainly on MDF and plywood which is usually pretty hard on bits due to the glue content. This has been working great for quite a few boards now and still seems quite sharp!

This upcut spiral 1/4 router bit came in a standard plastic end mill case that protected it during transit. However, the case had no labeling on it and the bag it came in was rather cryptic as well. The first thing I did was label the small case. The nano-blue coating covered the top end of the bit evenly and cleanly. The spiral bit cut down to create grooves for mortises very nicely and easily. Also, the same for several dados I cut in walnut and maple. The top edge was just ok but that is to be expected in a upcut bit. The upcut does clear away debris nicely. The bit was sharp and stayed that way through the jobs I have done so far. Very Decent bit that should serve me for quite a while.

This is a 1/4 inch Shank Upcut Spiral Router Bits with a 1/4 inch Cutting Diameter made with Solid Carbide with Nano Blue Coating. Im using it in my CNC End Mill for Wood carving/cutting. This bit is sharp and since its an upcut bit it pulls the sawdust up out of the cut leaving a smooth bottom but leaves the sides a little rougher. This bit works good and a little sanding cleans up the minor imperfection on the sides of the cut.

Ive used several different EANOSIC bits and they have all been of consistent quality. This is no exception, it works well in ash and other hardwoods both on a standard router as well as a Shaper Origin for which upcut bits work the best. The coating seems to make at least a little difference in reducing burning compared to no coating, but I might be imagining this.

Works well and holds a good cutting edge.

This is a good quality upcut router bit. The bit is nice and sharp and spins perfectly in my palm router. (in my CNC). The bit comes in a standard bit tube and stores nicely along side your other bits. I have used this bit only once, but I have the same sized EANOSIC downcut bit that I have been using for months now and its cuts and quality are still very nice. So I am expecting the same from this upcut bit. I am very happy with this bit.