ECCPP Lift Support Front Hood Struts Gas Springs for Toyota Avalon 2013-2016,for Toyota Camry 2012-2016 Compatible with 6757 Strut Set of 2
-
Helper
> 3 dayAffordable replacement for the original hood struts. They fit fine but despite the instructions stating to install them in the same direction as the original pair. One end is slightly tilted while the other is straight. Tilted must install on the hood per the OE, leaving the rod facing down attached to the body and with the receiving cylinder attached to the hood. Other than this discrepancy the product does indeed hold the hood up.
-
Haaziq Loftin Sr.
> 3 dayVery easy to install and the price was great!
-
John T.
> 3 dayWhile Im not one to just leave a review for any item, I felt I had to with this one. These fit my wifes 2012 Camry perfectly and i installed them in about 5 minutes. Compared to what the dealership will charge you these are a simple DIY that will save you from being had by the dealership. All you need is a small flat head screw driver to remove the old ones. Simply pry the locking tab on the back side of the ends slightly and the old ones pop right off. Afterward just pop the new struts on and your good to go. Id buy these again any day.
-
Napsterbater
> 3 dayTheyre cheap fast to install they do exactly what theyre supposed to do One of them was actually enough to hold the hood up but of course installed both as both struts on the vehicle were bad. One minor note these were reversed in a sense compared to the OEM ones on the car, And Im talking about the fat part of the cylinder versus the narrow part, pay attention to the ends One of them is angled match that to whichever side is angled on your vehicle, In my case on the 2012 Toyota Camry the angled one was connected to the hood itself, But if you were to base it solely on the fat and skinny parts of the strut they are reversed versue the OEM, Note this has no other effect on installation or use, So Im not taking any stars off.
-
kelly nguyen
> 3 dayThey are fine , just would be better if they put a tool along
-
james bissette
> 3 dayI bought these for my daughter’s Toyota Camry while I was on vacation visiting. It came in one day and I was able to pop the old ones off and place these on and they worked like they were supposed to. Held the hood up great. O’Reily auto wanted 27.99 each so these were a great deal for two. I recommend them as a father always being a dad and looking out for my daughter and her car care.
-
MScott
> 3 dayPrefect replacement for the factory originals. So far they do a good job of holding the hood up.
-
Car (:
Greater than one weekWay more affordable than the dealership and it was really easy to install. So far it’s been great, 10/10
-
Tony
> 3 dayLo instalé en un Toyota Camry SE 2015, fue fácil de instalar y poseen buena elasticidad.
-
Ati
Greater than one weekEasy to install. Not too different than oem but it requires more force to close the hood compared to oem. Installation requires two people but I did it alone and took me about 30min including the take off of oem ones.