ELEGOO Mercury Plus 2.0 Wash and Cure Station, Upgraded 2 in 1 Design Washing UV Resin Curing Machine with Washing Container and Busket for LCD/DLP/SLA Mars Photon S Photon Mono 3D Printed Models

The deal you get for this product is hands down great but it comes with its own downsides. I have used this curing station not more than 5 times and resin leaked into the spinner on the bottom, and now my IPA wont get spun around to clean my prints. I have tried to clean it out to make it spin again but with no luck so instead of saving a couple of bucks go for the metal finished curing station

Spent 10 months begging for customer support. Went through six elegoo representatives before being shipped a replacement wheels for wash machine and it took another month to recieve in mail. Took an hour to replace the two wheels and discovered the problem to still exist. The motor and wheels grind on eachother and machine is totally inoperable. Extremely frustrating! Bought an anycubic wash to replace this and works perfect. Shame on you for terrible support elegoo.

Works as intended. Easily setup and operation.

Great product.

I bought this a while ago after I bought my printer. I tried a small ultra sonic cleaner for nail techs and cured my prints by setting them in the sun and both were just bad ideas so I went ahead a bought this wash and cure station and it made things so much easier! Theres not much to say aside from it works! I was worried it wouldnt clean as well as an ultra sonic cleaner but I havent had any problems with it washing my prints at all. They come out looking great then just swap the bucket for the plate and run it for a minute or two on both sides and it cures my prints very well. Ive also used it to wash and cure prints from small furniture for D&D to full 1 foot tall statue prints.

I bought this to use with my Anycubic Photon Mono X2, the build plate fits perfectly on the supports within the washing station. This allows the build plate to be washed as well. I appreciate that the spinner will spin in one direction, then about half way through the cleaning cycle it slows down and spins in the other direction. I always put my prints through an initial dirty wash in a separate container, side note: a salad spinner works great, then move the prints to the washing station. This keeps the alcohol clean and lasts longer. The Curing station needs some assembly but the directions are easy to understand. One light tower is connected to two connections, and the other tower is connected to one connection so it is very difficult to do it wrong. They include all the necessary screws and tools to assemble. There is a sticker on one corner of the curing station lid, this sticker is used in conjunction with a sensor on the Left tower to ensure the lid is in place. I like this safety feature.

Baught this for final rinse.

Easy use

very easy to use and interface is intuitive. works very well and it does everything you need after your print is done.

Works great, so easy to use