ENOMAKER BL Touch Probe Pin Replacement Smart Auto Bed Leveling Push-Pin Needle Self Level Sensor Probe Tips for Bltouch, 3D Touch (5 PCS)

My bltouch is an older model from maybe 4 or more years ago. The pin on my bltouch is 2mm. These pins were 2.4mm. I opened up the hole in my bltouch to 2.5mm to fit these pins.

Not sure why these break so fast but so far have only had each one Ive used last a week before failing to work.

Slid right into place and is like i never had to replace the original probe at all.

This was a perfect fit for me Ender 5 plus BL touch. Just unscrewed the grub screw at the top, popped the old one out, then new one in. Not sure I even really needed to adjust my Z stop, but did anyway to save time.

nothing fancy. they do exactly what they were made to do at a fraction of the cost of others.

Only things you might need to do - cut tiny plastic leftovers from the tip and change Probe Z Offset in Marlin configuration to fit new probe.

Works as expected. The images compare the original probe (left) and replacement probe (right) along with genuine BL Touch devices. A better value by far than getting the single OEM probe that costs more. Ive already run several bed leveling tests successfully. Deploys, stows, and tests as expected. Not a huge difference compared to the original probe. Would recommend especially since tyere is a 10% off coupon right now.

These work great in my genuine bltouch. Looking at them I cannot tell the difference from the original, except these are not broken.

Worked perfectly!

Fit perfect! Cheap quick repair