ENOMAKER BL Touch Probe Pin Replacement Smart Auto Bed Leveling Push-Pin Needle Self Level Sensor Probe Tips for Bltouch, 3D Touch (5 PCS)

Replaced pin following a gigantic print blob failure. Found it rather easy to replace. The probe pin was a perfect fit for my Creality Ender 5 Plus printer. I do recommend this.

Works as expected. The images compare the original probe (left) and replacement probe (right) along with genuine BL Touch devices. A better value by far than getting the single OEM probe that costs more. Ive already run several bed leveling tests successfully. Deploys, stows, and tests as expected. Not a huge difference compared to the original probe. Would recommend especially since tyere is a 10% off coupon right now.

Keep some on hand. I have a fail and the original stick of the 3D touch brake. This was a remove, put and done.

drop in replacement and working better than the BLTouch delivered in a CR10SPros .

These work great in my genuine bltouch. Looking at them I cannot tell the difference from the original, except these are not broken.

This was a perfect fit for me Ender 5 plus BL touch. Just unscrewed the grub screw at the top, popped the old one out, then new one in. Not sure I even really needed to adjust my Z stop, but did anyway to save time.

Very high quality!

Worked perfectly!

Slid right into place and is like i never had to replace the original probe at all.

Only things you might need to do - cut tiny plastic leftovers from the tip and change Probe Z Offset in Marlin configuration to fit new probe.