F1RST LAYER New Cap

It works great a little bit long but def would do buy again

This kit was exactly what I needed to return my Creality CR10-S Pro to service. Appears to be original OEM parts. Has enough Capricorn tubing for TWO replacements. Came with fittings in two thread sizes (total of four fittings).

The tubing is very low friction/slick and difficult to get a firm grip on. This is good news for your filament. Be sure to get a nice flush clean cut before installing.

Installed on my Ender 3 V2. It comes with enough tubing to do two bowden tube set ups. I guess if you mess up cutting it you have enough to replace it. Or maybe replace it if it wears out. The fitting of the blue rings is very tight. I was worried about it popping off, but it has held for a few days with no movement. Over all I am pretty happy with it. I took off a star because the blue ring on the extruder end was so tight it slipped off the first time I put it on and tried to move it a little. I may be picky but it just seemed a bit too tight.

I had used my spares up and saw this kit and ordered it. Great decision. Tubing went right onto the printer and so did one of the nozzles. Ill order it again when next my spares run out.

Actually purchased for the connectors as my extruder one failed. Never can have too much extra PFTE tubing. Bought a used ender 3 with some upgrades. It came with tubing but found if I got a clog I occasionally had to trim the end. Did the hot end fix which decreased the frequency of clogging on ender 3 but used a bit of PTFE to stick down in the hot end before a PLA+ washer. Would preferred to have a metal washer as the heat eventually will tear up the piece of PTFE but this fix lasts a month or two with nearly constant printing. Much better than having a clog every few prints because PTFE tubing moves within the connector creating a gap for the filament to creep into. Recommend having this on hand even if you don’t need it at the moment. Nozzles also work well.

My print quality is much better with Capricorn Bowden Tubes. Before I had a situation where as I was removing the filament, plastic got stuck to the bowden tube that came with my printer.