FivePears 1/2 Inch Shank Rabbet Router Bit with 6 Bearings Set, Adjustable Multiple Depths 1/8, 1/4, 5/16, 3/8, 7/16, 1/2 for Beginner DIY Woodwork …

Beautiful set. I use to cut reveals in picture frames. Accurate. Very well constructed. Easy to change depth.

So far so good. Appears to be decent quality.

I had really high hopes for this tool, but it was a total failure. The first time I tried to use it, I went to loosen the small (3 mm?) screw that holds the bearing onto the bit shaft, the screw head stripped. I was using the Allen key that they provided. They tightened the bearing screw soooo tight to the shaft, I couldn’t change out the bearing to the one I wanted to use. After reading other reviews, I now see that there are a bunch of people that have the exact same experience. Very disappointing.

Screw holding in the pieces could be stronger. Works just fine but the first time I used it the screw backed off and then the bearing flow off. So I put it back together and tightened the screw a little bit more and that stripped the screw. I had the correct (included) Allen wrench so no issue on correct size there, seems to be just a weak screw head.

This 1/4 Shank Router Rabbit works Great and its a Great Value. Glad I bought it.

The largest sized spacer in the pack worked great, but the next size down was too much of a difference in size and I was not able to control it well enough to prevent damage to the cutter. I had to take it to a professional. Were I to try this again, I would need to source a bearing that would be 2nd largest. There was two of the same size in the pack so they could have provided an alternate size.

Works great with no tearout. Only complaint was the setscrew holding the bearing when shipped was so tight the allen wrench could not remove it. Had to use vice grips.

Worked well. Although I only used one bearing, it did add versatility. I put it under some rough treatment (that a router bit shouldn’t) & it stood up great.

For the cost, you cant beat it. I have used this to make multiple rabbet joints and it has performed flawlessly. I havent had it for a long time so I can speak to how long the edge will last, but so far Im very content with the product.

Overall, the bit seems to be very solid and good. However, the bearings are total junk even when fully tightened they were extremely wobbly and loose and hit the blade shooting out sparks possibly defective. However, I think it was just poorly made. It has been returned. You get what you pay for!