Front Face Plate Faceplate Shell Case Cover Replacement for Sony PSP 1000 1001 Fat (Black)

Everything was fine except this part it’s right underneath the psp logo and can cause joystick drag if the bottom of the shell isn’t secure the bottom one is the original while the top is the new one

This product was a perfect fit for my psp 1001 and it was very easy to install

The fit and finish of this faceplate is bad. I expected it to be a little different as it’s a third party item. But it was way off and it interfered with my ability to use the buttons. I returned it.

I read the complaints about this faceplate but I dont think they realized how much plastic film was on it to protect it. I took 3 off and its scratch free. Everything lined up and screwed together fine. Slight issue with a bit of flashing on a button hole but took 2 seconds with a hobby knife to clean it up. Looks great on the console.

It looks almost exactly like the original. Fit is pretty good. Only the circle button didn’t fit with it, had to file one of the little tabs on that button down to make it work, all else is pretty much fine and nobody can tell the difference. Looks good.

Its not bad for the price. obviously it is not the same as the original and you will able to tell right away bjt its pretty close. the most noticeable thing is that the screen is attached to the plate like newer models of the psp. Also, the holes of where you see the lights On and Off are not plugged. The other holes that look like they were for the speakers are plugged but the original had them but the psp 1000 didnt have speakers in that location. Last, I struggled a little to put one screw because it wasnt centered in the right spot but I managed to put it in. Overall, its way better than the crap you get on ebay and the psp looks like new.

Great hardshell for my psp fits perfectly!! A+ to the construction

Fitment is bad due to poor cleaning of extra plastic,also the bottom middle screw point was broken or incompletely molded so the faceplate doesnt actually get held down correctly. Big gap between the faceplate and the actual device, and also the holes for the buttons are oversized,careful getting lint in there and ruining your screen or short circuiting the mother board.

Horrible fitment did not work for my 1001 I’m sure if I did some drilling to make it work it would have worked but what’s the point of buying something new if you have to mod it? It should work out the box!

As expected, cannot complain.