HAUTMEC Swaging Tool 6 In 1 PL0032
-
James Walth
> 24 hourEasy to use.
-
Tony C.
> 24 hourworks
-
Marcus
> 24 hourNo handle so if you use the last graduation no way to extract tool...
-
jcav
> 24 hourI had to flare some Eva Barrier 4mm size beer line tubing over the faucet shanks of my kegerator, which were much larger and you cant just push it on. I heated the very end of the tube with a heat gun and then slid this tool inside and up the line. After it cooled I did this one more time and it was able to slide to the diameter that I needed to go over the faucet shanks. It did not damage the inside of the tubing either. So easy and worked great!
-
R. B.
> 24 hourFor attaching two pieces of copper pipe together without the cost of a coupler and only 1 solder joint. Threw it into the toolbox and will likely pass it down for a few generations. Looks well made.
-
AHW
> 24 hourUsed it to expand he ends of electrical tubing sections used to pin some 4” post section at ground surface—to provide support & not allow tubing to slip through drilled holes.
-
Vernon
> 24 hourCould be a little bigger
-
Great Dane
> 24 hourVery nice. Perfect for my project and good value.
-
Sax1948
> 24 hourI expected it to be polished , like the one in the photo …
-
Tigy GL
> 24 hourI had hoped to expand the 1/2 mini watering system to take connector as it is a very tight fit, but it didnt work.
This HAUTMEC Swaging Tool is used to mate like-size copper tubing. The tool eliminates the need for couplings and has a variety of swaging size capabilities, from 3/16
Features:
- Application: For Soft Copper, Brass, Aluminum and Thin Walled Tubing
- Capacity Tubing O.D. (In.): 3/16, 1/4, 5/16, 3/8, 1/2, 5/8
- Item: Swaging Tool
- Overall Length (In.): 6-5/16
- Construction: Hardened Steel
- Item Type: Swaging Tool Set
- Durable, hardened steel construction
- Insert tool into copper, brass or aluminum tubing and only need hammer to strike
- Only one solder joint required