HLOFIZI 6-3/8 Hole Saw for 6 Recessed Lights, Carbide Grit Holes Saw Cutting Plaster Drywall Ceiling Sheetrock, Green

With the cut away design it is easy to start the hole saw on a point and then remove the debris after the hole is cut. The hole saw also cuts very well.

Ive had many different types of hole saws for cutting in recessed and can lights. This one is by far the best so far. Im an electrician and use this tool all the time. Ive already cut about 100 lights in with this. Ive cut into drywall and plaster and it shows no wear or slowing down. Ive had hole saws go bad after 1 hole. If this one ever does take a crap, Im immediately buying another. I hope they sell this in other sizes.

Would buy again very nice on plaster. Which u find in florida. Also buy plastic shield wont regret it.

Strong item, works with 1/2 drills

Very good

Update: The seller apologized and offered to send me a new product at no additional cost. They also gave me a refund. This kind of customer service should be 5 stars. OLD COMMENTARY: It arrived incomplete in its parts. The bits were not in the box. I needed to use it to open some holes, so I used some dewalt bits which fit perfectly with these saw holes. But I do not buy this brand again due to the fact that its parts are not delivered complete.

Now in my application I used this to cut 13 holes through a plaster ceiling with the old 50’s gypsum with the holes underneath. As was it took about 1 minute a hole & I could probably do another 13 or more with it. If that ceiling had metal lathe I’m not sure how the product would withstand. Overall good product

Ive used three different types of hole saws for installing ceiling lights. Standard holesaws tended to dull after a few cuts. One was similar to this but did not have a ring that sat flush to the surface and instead had gaps around the ring for some reason. That tended to buck something fierce and also chewed up the texture around the hole. Super pleased with this product. Ive just finished 12 holes and the 12th has just as nice an edge as the 1st. Expect a little bucking but minimal compared to other saws. The holes are clean edged and the swirl paint ceiling did not flake or crumble around the saw as it did with others. Dust is always a nuisance with any ceiling hole saw so make sure you get a clear plastic guard and it doesnt hurt to have an assistant holding a shop vac up near the ceiling too although be careful not to rub a dirty shopvac nozzle on your ceiling. Great product.

Used to make garage wall holes for blown-in insulation. Cut all of the holes nicely but very messy because of the wide KERF. Produces an enormous amount of drywall dust.

A must have for hard wall finishes. We have a level 5 finish on our walls. I discovered this when I was trying to cut a hole in the wall with my rotary bit and the wall cut the bit off. Grabbed my sawzaw and the wall ate the teeth off the blade. I ended up buying a plaster saw to cut through. Needless to say a regular hole saw wouldnt last a couple holes. This thing cuts right through with no wear or problems. Less dust than a traditional saw, and smoother cut. The customer support is excellent as well. I was missing a part in my order and they shipped a replacement immediately. Highly recommended.