HQMaster Spiral Router Bits Down Cut 1/4 inch Shank Solid Carbide Nano Blue Coated Spiral Downcut CNC Bits End Mill for Wood Cut Carving Engraver (1/8 Cutting Diameter)

This cutter is dimensionally accurate according to my caliper. That is good as sometimes 6mm shank are sold as 1/4 (6.35mm). Under magnification the ball end is smooth without burrs. It is only 2-flute so I wouldnt try to cut metal with it but wood and plastic should be fine.

This 1/8 cutting 1/4 shank ball nose bit came in a standard end mill case that protected it during transit. The case was nicely labeled so you dont have to. The nano-blue coating covered the top end of the bit evenly and cleanly. The ball nose left a nicely rounded bottom on the groove. The bit cut easily and dispelled chips well due to the up-cut flute design. This bit seems well designed and stayed sharp through my testing on both soft and hardwoods and I expect to get a good long life out of this bit.

The HQMaster 1/8 inch Ball Nose End Mill will be used to make a decorative edge on jewelry boxes. The bit was tested in Cherry wood and produced a perfect clean cut.

Like clamps, you can never heave enough router bits. Well, that is my take. And like they last forever, right? This bit is well made, good fit and finish. So far it cuts as it should, cuts very nicely. I cant say how it will last, that will take time and use, but Ill update this if anything changes. Comes in a nice plastic storage tubes, I like these tubes. And the end of the tube holes the bit nice and tight. I also REALLY like that they put a label on the tube, with the size, that is so nice. Ive reviewed quite a few router bits and its rare foe them to have any label on the tube, so hats off to this company. Great bit, great price, would recommend.

Tested in mild steel. The cut was very smooth as the bit is very sharp. Should work well in many materials. After testing I used a 1/8 drill to check the size. The naked eye said it was a little large. Was it runout from my setup ? Bent bit ? Manufacturing defect? I checked with a micrometer and found the bit measured .126 Probably not a really big deal in most cases. I will call it a quality control issue. Or maybe when these are sent to us vine reviewers we get the ones that didn’t pass quality control. Might just be the perfect size for some project.

I bought the 1/8” cutting diameter bit, and used it with my router and DIY circle jig to cut a perfect, 11” diameter circle in 1/2” plywood. The down cut left no splinters on the top side of the plywood, and very few on the bottom side. I do not know how long it will last, but it worked very well on its maiden voyage.

This is a great end mill for doing 3d cutting. Makes nice clean cuts leaving a nice finish. The price makes this even a better value. Time will tell but so far this has been my goto bit for 3d cuts. Comes packaged well and arrived quickly. I will buy more of these bits

Nice ball nose CNC router bit. Good quality. Clean, sharp cutting edges along entire flute.

While I would prefer a bearing bit (and I ordered one) this bit came within a few days of order and worked just fine for my needs. I needed to duplicate some Plexiglass objects and so set up the bit to travel along the original and cut the part out. My concern was burning the original (without having a bearing guide) but that was not the case and given the correct speed and movement speed this bit worked like a champ and stayed sharp for the duration of my project. I was cutting 1/4 Plexi and while I thought heat might be a problem it seemed to work just fine

This is a nice router bit to finish up details when coming close to the edges of a pattern line. Its well made and nicely machined. I would not use it to hog out material, but for detail work, I would recommend it.