KOOKYE Lilypad LEDs Red/Yellow/White/Blue/Green (25x Lilypad LED) Wearable E-Textile Sewable Electronicsfor Arduino Rapsberry Pi Microcontroller Board

Im working on a couple of different Lilypad LED projects - a hat and a vest. These are priced right, bright and easy to use. For clothing, conductive thread is the best bet. Im used to the more traditional old-school - use thin wire, solder it to the LEDs and sew the wires in a few spots to keep it in place and pull them through hems and along seams. Conductive thread makes this so much easier. These light up between 2.5 and 5.5 volts (5.5 is the max for Lilypad .) That means that you can power these manually via a USB battery pack.

I use these to light my LEGO City, and they are fantastic. My wife is using them to illuminate the cards she makes.

I bought this set for my weaving project. They are working pretty good.

I knew they were small but boy are they small. I thought the cables for installation came with but I was wrong. I do have the cables needed so I’ll still be able to get the project done. I tested them all prior to using them because it’s something I do with any just received lights. It’s just easier now instead of finding a non working one later. I’m happy with the quality of them and would purchase them again. Four Stars!!!

All working out of the box. Nice set of lilypad leds. Voltage is 3 volts. Decent soldering on all of them.

I like these. Theyre small and easy to incorporate into all kinds of projects. They are clearly labeled with the appropriate color on the back, since they all look the same when not powered on. All of the colors (my set included red, green, blue, white, and yellow) are bright even at lower voltages. Unfortunately they dont come with any data or documentation, but after a little searching it looks like these are 5v components (although I tested at 3.3v and theyre still bright at that voltage).

These will come attached but are very easy to break apart. Nice small design with good size pads for easy soldering. These have a built in 150 Ohm resistor (R) so they can be connected directly to a voltage supply.

These work just fine. I used a few on a glove wearable project and they were super bright.

These LEDs work well with any electric circuit. We have used them successfully with both our Arduino uno and our lillypad sewable circuits kit. The lights are bright, the colors are pretty intense. The blue and yellow are less intense than the red orange and green. There are 5 each of 5 different colors. They are easy to use individually. A great addition to our STEM station in the garage. I cant wait to see what ideas my kids come up with for these.

I was surprised by their small size. It is a good think really because I’m using them for wearable electronics