LF10-4H

I ordered this pressure switch because my air compressor was continually leaking air at the switch. The on/off lever was different than original but I was able to loosen the four screws that attach switch to the base just enough to get lever out (with out losing spring) and I swapped it with original lever from old switch. After installing this new switch, it was leaking air too - again at the unloader valve. I then discovered that the switch wasnt the problem. It turns out the check valve on top of the tank was leaking. I removed, cleaned and replaced the check valve and that fixed the leak. The switch works fine. It only required a little adjustment to get it to shut off at the correct pressure.

All good. Very satisfied.

Only problem was start sensor was in different location but works. Had to get different line and is more prone to damage in new location

Arrived with all the uploader parts missing!

Small and compact. Overpressure relief valve mounted on switch is vertical instead of a 90 degree conection. Gromments for wire are too large in diameter.

It is factory set for a much higher pressure than advertised (175 psi). Be mindful of this because you could get seriously hurt if your tank is rated at a lower maximum pressure. It can be adjusted down but make sure you check the cut off setting after you install it.

Great product for the money and it was shipped promptly.

Exactly what part I needed and fitted my compressor perfectly

product is exactly as represented. not sure why i need more words but apparently more words are required for a rating?

The shell was cracked and a few pieces broke off, but its only cosmetic. Works as it should.