MCIGICM 10pcs Male Header Pin, 40 Pin Header Strip (2.54 mm) for Arduino Connector

I had some components that needed pins. It was very easy to snap them down to the size I needed, soldered on very easily. It was wonderful

Quality and quantity at a great price! These pins worked perfectly on an iRangeX Multi Module board to enable firmware updates.

Cant beat them. I was impressed at how well they were made. Good product

I dont need gold plating for spare pins.

VERY fast delivery. Exactly as described.

Works exactly as expected.

-I agree with the other reviewer re: solderability. I could barely get my aggressively fluxed solder to stick until I cleaned the solder end thoroughly first. I used 99% rubbing alcohol, wiped on and wiped dry, twice just to make sure. Solder problem solved. -They dont break apart as precisely as some of the others by hand, using needle nose pliers helps a lot.

This has the same spacing as standard Arduino headers. The long side is right for going into the raised sockets on the Arduino (or a shield with stacking headers). The top pin comes out the top of the next board by 2 mm or a little less. Perfect for when you want a soldered connection but will not be adding anything to the top side. Im working on a project where I have to stack and unstack custom shields multiple times. These pins stand up to that nicely. Much better than stacking headers, which always seem to use flimsy legs that bend too easily. Of course you should still make an effort to move these pins in and out vertically, but Im not perfect and so far my slips have caused no damage.

These strips fit directly into a standard breadboard, and they can be split to length without sacrificing any pins by snapping in between two pins.

These are exactly as described and are easy to break at the point that you want. If you only need a four-pin header then you can easily break off four pins. Thank you for a great experience. Fast shipping and good products make for good transactions.