Micro-Swiss All Metal Hotend Kit for Creality CR-10s PRO/CR-10 Max/Ender 3 V2 Neo

I have the Creality CR-10s Pro v2. The stock hotend was failing. I know that Mirco Swiss are some of the best 3d printer upgrade parts out there so I purchased this. I had to do some re-calibration but after that this hotend prints much better than the stock hotend...IMO.

This hotend has its ups and downs. Personally Im switching back to the original one that came with my CR-10S PRO. I never had any issues with it and this one keeps getting clogged up. I know what Im doing and Ive seated it correctly but it still clogs up. If I turn on the printer after its been resting I make sure to turn the nozzle heat up to 230 degrees and make sure it is flowing nicely prior to starting the next print. It still clogged up on me on two separate occasions. Both after 24 hours of printing. Trust me, that sucks! Ive wasted enough filament on this and have ordered an original replacement from Creality.

Finally able to print PETG with this on my CR-10S Pro V2. Amazing quality. Definitely a must for an upgrade to your printer for quality and versatility.

This is a direct replacement for the factory hot end. Remove the old one, trim the bowdin tube square, pre heat the hot end before tightening the nozzle. Then print! This works really well.

Bought this for a cr10s pro. Fit up perfectly. Came with everything you need. Product seems of high quality and the silicone sock is higher quality than stock. It is slightly longer than stock so be careful when setting your z height up for the first time. Upped temps by 10 degrees for pla and its been printing fine.

Replaced stock hotend on my Cr10s Pro V2, worked perfectly with a 0.6mm nozzle, ZERO jams, whereas the stock hotend jammed constantly, would 100% recommend.