Official Creality 3D Hotend Silicone Sock Set of Three and Creality Sticker for Ender 3 CR-10 CR-10S

Always good to have extra socks!

product is what it says it is, works like how it should work, fits like how it should fit.

This is exactly the same as the original. Good quality.

Fit perfect, helps keep temperature from fluctuating. Better than OEM insulation.

These don’t fit. They are too tall and are loose around the stock hot end

I kept using the hotend with original insulation. It looked nasty. It came off so it was the time. This thing fits nicely. I dont know if this helps hold temperature but it looks nice.

I replaced the charred crust of cotton and tape was all that remained of the stock insulation on two of my Ender 3s. Flakes of the insulation had began dropping onto my prints and getting caught in the matrix. The hardest part of the installation was cleaning the heat block without damaging the thermresistor or heater module. I am happy with the results.

There are only two sides of this with tabs to grab onto the heat block. It will not stay on during prints and has to be held on with wire or some other way. Total junk, do not buy.

I received 3 Mk 10 socks that didn’t fit with the CR 10s as promised. There is currently no option to return.

Fits great. Nice bumper sticker.