Opret 5 Pcs FEP Release Film Replacement for ELEGOO Saturn/ANYCUBIC Photon Mono X LCD 3D Printer 185x260mm 0.15mm Thickness 95% Light Transmittance for 8.9 & 9.1 inch Screens

Went on easy. Instructions were clear and concise. I also learned, from these instructions, that one is to remove a film on each side of the fep film. Well, that explains an issue I was having with another cheap brand. Ill have to go back and give them another go, though if they had said as much on their packaging I wouldnt be in this mess to begin with, so who knows.

This had turned out to be the best FEP yet for my mars 2 pro.

I have gone through so many of these since I started resin 3d printing. The only thing I do not like about them is how long it takes to switch and undo all the screws but this is no fault to this product. If you resin 3d print you need to put this store in your favorites and be ready to order. Replacing parts in a resin 3d printer is a must

I got these as back ups for when I needed to replace the factory installed FEP that came with my Mars 3. 5 came in the package, they were big enough to fit the vat and still have some left to trim.

Good funcionality

Works great. Easy install.

Worked as it should

this film is just as durable as the original, if not more so. i was able to easily replace the old one with this. my test prints after installing this film turned out proper with no errors. this is a good product and when i am in need of more i may use this brand again. good pricing for the amount you get

As advertised. Fit my Photon S vat. Good quality FEP. I would absolutely buy this again.

This won’t work with the Anycubic Photon Mono stock vat. If however, you replace the vat with an aftermarket one (for example aluminum) then they work great. We replaced the vat as I wanted to be able to use lower-cost FEP replacement than Anycubic’s and it also doesn’t tie me to worrying about their stock.