Opret 5 Pcs FEP Release Film Replacement for ELEGOO Saturn/ANYCUBIC Photon Mono X LCD 3D Printer 185x260mm 0.15mm Thickness 95% Light Transmittance for 8.9 & 9.1 inch Screens

I got these as back ups for when I needed to replace the factory installed FEP that came with my Mars 3. 5 came in the package, they were big enough to fit the vat and still have some left to trim.

As advertised. Fit my Photon S vat. Good quality FEP. I would absolutely buy this again.

First time changing my FEP sheet out on my Anycubic Photon. Read some other review on this product and figured give it a shot. The packaging is very nice. Seeing as the sheets are incredibly thin and fragile the box they came in was well cushioned. However there was not the best instructions on how to change and tune your FEP. Like tuning a drum you need to have the skin be a certain tightness to have a precise tone. Same goes for the FEP. Aside from looking up a Youtube video on changing the FEP the print quality has been amazing.

Worked as it should

This won’t work with the Anycubic Photon Mono stock vat. If however, you replace the vat with an aftermarket one (for example aluminum) then they work great. We replaced the vat as I wanted to be able to use lower-cost FEP replacement than Anycubic’s and it also doesn’t tie me to worrying about their stock.

Muy caro para el material y función

N/a

Good funcionality

Follow the directions. Be sure to use your current vat holes. Don’t make the holes too big

did not seal leak all over