PGN (4 Pack) 6201-2RS Bearing - Lubricated Chrome Steel Sealed Ball Bearing - 12x32x10mm Bearings with Rubber Seal & High RPM Support

Work well on my pump

Theyre not the best bearings but they work as they should. Used them for my Baja Doodlebug and they have held up so far. Definitely overpriced though... Sure the exact same ones can be bought cheaper, but if youre in a pinch like me youre paying for the convenience of getting them in a timely manner.

Quiet again and now to finish the restoration

I bought my father two sets of these because he needed them for his meat slicers He popped them in and there was a lot of noise with additional vibrations. He went back to the originals after that Buy one set to test before buying two

Bought these as a replacement for my 8ft. lawn windmill. These did the trick. Work much better than originals. Make sure you pop off the plastic sides with a pick and grease them. If you have a grease fitting leave one plastic side off and put the other back in. Place the side without the plastic into the tube first. This will allow the bearing to take grease from your fitting and the grease will not be pushed out the other side.

Super good value for the money!

Bought them for a decretive windmill in the back yard. The bearings that came with the windmill self destructed in a month, these seem strong and smooth....

Replaced a faulty one!

thank you

Used these to rebuild an alternator.