Presa Metal Peg Board Shelving Hooks, 2-inch, 25-pack

Good quality, like the ball on the end to prevent injuries

These were perfectly well. The fact that they are so well design makes the installation easy. I hope they recommend

GREAT PRODUCT!!! Works Great!! Just not on metal pegboard!

excellent value and quality

Fit great. Used to mount firearms on pegboard. Thousands of dollars held up by these little guys and I have no doubts they will hold. Very nice!

I got the package of 25 and find them so handy I may get some more. They lock into the peg board very well and stay there.

Works perfectly. Great heavy duty hooks. I work in procurement for a gourmet grocery retailer and these are the same better than my commercial hooks.

Extremely sturdy

These Presa 2” single arm pegboard hooks (25-pak) are sturdy & look exactly like the ad photo. The wire diameter is 0.205” – typical for hooks that fit ¼-inch pegboard. The ad incorrectly states, “designed to fit 1/8” holes” – should be “For ¼-inch pegboard – 0.205” (5.21 mm) dia. wire”. I prefer the hook arm to be horizontal & these angle upward because the arm’s bend is greater than 90 degrees (as photo shows) and the wire will definitely NOT flex down due to the weight of typical items you would hang. But, I reworked all the hooks by clamping tightly in a vise where the weld is - with the arm above the vise jaws & the short end that rests against the pegboard out a bit from the side of the jaws; a few blows with a hammer on that short end makes the bend 90 degrees without breaking any welds (I reworked Presa 4” hooks the same way). With the 2” hook installed on pegboard, the horizontal part of the arm is 1.9” from the pegboard & 3.0 – 3.1” to ball’s end. An item needs a hole larger than 5/16” to fit over the ball.

As a quilter, I purchased these to hang my expensive rulers on a pegboard. Unfortunately, the width of the knob on the end made them too big to fit through the precut holes on my rulers. It wasnt worth the cost to return them and I have found other uses. However, I was disappointed that I could not use them for the intended purchase. If it is helpful to you, most of my rulers are Omnigrid and have 1/4 inch holes.