QWORK 1/2 - 14 NPT Pipe Tap, Carbon Steel, for Clean and Re-thread Damaged or Jam Pipe Threads

I used it to clean up the threads in my camper hot water heater anode rod hole. The threads had become so crusted with mineral deposits that the new anode rod would not thread in far enough and would seep whenever there was pressure in the tank. After using this tap to clean up the threads, the new rod sealed perfectly.

I bought this tap for a old water line repair I have to make and this tap may save me some time and money. Thanks Amazon.

Had a few fittings where the threads needed cleaned up and this did the job perfectly.

Product was as advertised!

Good value for the money

Good value for the money

Had a shower head break off in the wall fitting. I was able to get some of it out but not all. So this tap was a bottoming type (means it is flat) and I was able to clean out all the left over threads in the wall fitting. Saved me form having to pull this apart to replace. Well worth it!

Does what it supposed to do.

I was very satisfied and would do it again!

The markings on this tap are not deeply engraved so one must be very careful not to make a mistake.