









QWORK 1/2 - 14 NPT Pipe Tap, Carbon Steel, for Clean and Re-thread Damaged or Jam Pipe Threads
-
Phil
> 24 hourI used it to clean up the threads in my camper hot water heater anode rod hole. The threads had become so crusted with mineral deposits that the new anode rod would not thread in far enough and would seep whenever there was pressure in the tank. After using this tap to clean up the threads, the new rod sealed perfectly.
-
Jerry JRY
> 24 hourWorked perfectly except that square end is larger than you might imagine. I had to use a socket to drive it into the pipe fitting.
-
ernest francis
> 24 hourWorked
-
Kit
> 24 hourThe markings on this tap are not deeply engraved so one must be very careful not to make a mistake.
-
Chico
> 24 hourDoes what it supposed to do.
-
Dave O.
> 24 hourThis product arrived very quickly and was well packaged. I used it for tapping holes in schedule 40 PVC and 1/4in clear acrylic sheet and it worked perfectly.
-
DWS
> 24 hourNeeded to chase some threads and it did a fine job, thanks
-
Edith Byler
> 24 hourI was very satisfied and would do it again!
-
Robert LHommedieu
> 24 hourNice quality at a very good price.
-
Mick D
> 24 hourHad a few fittings where the threads needed cleaned up and this did the job perfectly.