Replacement 5 Hook & Loop Pad For DeWalt DW421/DW423 Sander 2-pack# 151281-08

The Velcro portion of my old DW421 pad was peeling off. This fit perfectly. The only difference I noticed was the old pad had a metal plate, whereas this one is plastic. I dont expect that to cause any problems, but only time will tell.

The item is a good replacement at a good price. Fits my sander well.

I had a Porter Cable sander the pad went bad on from sitting in the heat. Tossed it and bought a DeWalt...same issues a few years later. Wish I knew about this before I tossed the PC one...these are much cheaper than replacing the whole sander. Bought the two pack so I had an extra one for in a couple of years.

As long as I have used it for a short time, its performance so far is good.

this pad replaced my old one and was easy to install.

They were out of balance so they shook the sander. Couldnt use them at all. Dont waste your money

I was amazed the the low cost yet superior wear and adhesion.

They fit my sander and work great!

They rub against the sander assembly

Nothing