Replacement Parts for iRobot Roomba i7 i7+ i3 i3+ i4 i4+ i6 i6+ i8 i8+ E5 E6 E7 &J7 J7+ Vacuum Cleaner,2 Set Rubber Brushes,8 HEPA Filters, 8 Side Brushes

The replacement rollers are too fat and the Roomba constantly thinks there’s something stuck and stops vacuuming.

Product fits ok. Although the dark green roller was designed with different treads. On first use vacuums for a few minutes gets stuck on carpet that the iRobot previously would vacuum without a problem. Reset iRobot and start it again. A few minutes later and it stops debris collector. Empty debris collector check for anything stuck anywhere and started again. Over and over it either gets stuck on anything and everything or errors over debris collector. I can’t get through a cleaning and its made the iRobot useless.

Kit came fast and fits my roomba i7 no problem. My only issue is that one of the rubber brushes seized up shortly after installing. Had to toss it not sure if it was defective or what but other than that the kit was fine.

Main Brushes get stuck and don’t roll!!!. The inner brass bearings get stuck with the main shaft after a couple of minutes rolling. The kit came with two sets and both didn’t work. Poor quality product don’t buy it!!!

Dont let them waste your time it does not work on the J7+. They also will not message you back to correct the issue. I returned it to amazon so they can deal with it.

I recommend that you don’t do like i do and try to save a little money. The rollers are too big and cause constant errors in the Roomba. The spinning brush is too long and had to be trimmed to work. Waste of money.

The replacement rubber brushes are not the same size as the original parts. It took me too long to figure out why the unit was not working. It would run and then stop after 1 minute of cleaning. I finally spent the extra money and bought replacement rollers from iRobot and now it works fine. Don’t by these.

Everything fit my vacum

Like

The roll brushes will prevent the iRobot from working and it will throw error codes.